+#~ msgid "Package %s is a virtual package provided by:\n"
+#~ msgstr "套件 %s 是虛擬套件，提供者為：\n"
+
+#, fuzzy
+#~ msgid " [Not candidate version]"
+#~ msgstr "候選版本"
+
+#~ msgid "You should explicitly select one to install."
+#~ msgstr "請您明確地選擇一個來進行安裝。"
+
+#~ msgid ""
+#~ "Package %s is not available, but is referred to by another package.\n"
+#~ "This may mean that the package is missing, has been obsoleted, or\n"
+#~ "is only available from another source\n"
+#~ msgstr ""
+#~ "無法取得套件 %s，但它卻被其它的套件引用了。\n"
+#~ "這意味著這個套件可能已經消失了、被廢棄了，或是只能由其他的來源取得\n"
+
+#~ msgid "However the following packages replace it:"
+#~ msgstr "然而，下列的套件取代了它："
+
+#, fuzzy
+#~ msgid "Package '%s' has no installation candidate"
+#~ msgstr "套件 %s 沒有可安裝的候選版本"
+
+#, fuzzy
+#~ msgid "Package '%s' is not installed, so not removed. Did you mean '%s'?\n"
+#~ msgstr "套件 %s 並沒有被安裝，所以也不會被移除\n"
+
+#, fuzzy
+#~ msgid "Package '%s' is not installed, so not removed\n"
+#~ msgstr "套件 %s 並沒有被安裝，所以也不會被移除\n"
+
+#, fuzzy
+#~ msgid "Note, selecting '%s' instead of '%s'\n"
+#~ msgstr "注意，選擇了以 %s 替代 %s\n"
+
+#~ msgid "Skipping %s, it is already installed and upgrade is not set.\n"
+#~ msgstr "忽略 %s，它已被安裝且沒有計劃要進行升級。\n"
+
+#, fuzzy
+#~ msgid "Skipping %s, it is not installed and only upgrades are requested.\n"
+#~ msgstr "忽略 %s，它已被安裝且沒有計劃要進行升級。\n"
+
+#~ msgid "Reinstallation of %s is not possible, it cannot be downloaded.\n"
+#~ msgstr "無法重新安裝 %s，因為它無法下載。\n"
+
+#~ msgid "%s is already the newest version.\n"
+#~ msgstr "%s 已經是最新版本了。\n"
+
+#, fuzzy
+#~ msgid "Selected version '%s' (%s) for '%s'\n"
+#~ msgstr "選定的版本為 %3$s 的 %1$s (%2$s)\n"
+
+#, fuzzy
+#~ msgid "Selected version '%s' (%s) for '%s' because of '%s'\n"
+#~ msgstr "選定的版本為 %3$s 的 %1$s (%2$s)\n"
+
+#~ msgid "This is not a valid DEB archive, it has no '%s', '%s' or '%s' member"
+#~ msgstr "這是個不正確的 DEB 套件檔，沒有 '%s', '%s' 或 '%s' 成員"
+
+#~ msgid "MD5Sum mismatch"
+#~ msgstr "MD5Sum 不符"
+
+#~ msgid ""
+#~ "I wasn't able to locate a file for the %s package. This might mean you "
+#~ "need to manually fix this package."
+#~ msgstr "找不到 %s 套件的某個檔案。這意味著您可能要手動修復這個套件。"
+
+#~ msgid "Can not write log, openpty() failed (/dev/pts not mounted?)\n"
+#~ msgstr "無法寫入記錄檔，openpty() 失敗（/dev/pts 未掛載？）\n"
+
+#, fuzzy
+#~ msgid "Skipping nonexistent file %s"
+#~ msgstr "開啟設定檔 %s"
+
+#~ msgid "Failed to remove %s"
+#~ msgstr "無法移除 %s"
+
+#~ msgid "Unable to create %s"
+#~ msgstr "無法建立 %s"
+
+#~ msgid "Failed to stat %sinfo"
+#~ msgstr "無法取得 %sinfo 的狀態"
+
+#~ msgid "The info and temp directories need to be on the same filesystem"
+#~ msgstr "資料目錄與暫存目錄需位於同一檔案系統中"
+
+#~ msgid "Failed to change to the admin dir %sinfo"
+#~ msgstr "無法切換至管理者目錄 %sinfo"
+
+#~ msgid "Internal error getting a package name"
+#~ msgstr "內部錯誤，無法取得套件名稱"
+
+#~ msgid "Reading file listing"
+#~ msgstr "正在讀取檔案清單"
+
+#~ msgid ""
+#~ "Failed to open the list file '%sinfo/%s'. If you cannot restore this file "
+#~ "then make it empty and immediately re-install the same version of the "
+#~ "package!"
+#~ msgstr ""
+#~ "無法開啟清單檔 %sinfo/%s。如果您無法將此檔案還原，請清除檔案內容，然後立即"
+#~ "重新安裝同一版本的套件！"
+
+#~ msgid "Failed reading the list file %sinfo/%s"
+#~ msgstr "無法讀取清單檔 %sinfo/%s"
+
+#~ msgid "Internal error getting a node"
+#~ msgstr "內部錯誤，無法取得節點"
+
+#~ msgid "Failed to open the diversions file %sdiversions"
+#~ msgstr "讀取抽換檔 %sdiversions 失敗"
+
+#~ msgid "The diversion file is corrupted"
+#~ msgstr "抽換檔已損壞"
+
+#~ msgid "Invalid line in the diversion file: %s"
+#~ msgstr "在抽換檔中的這一行有誤：%s"
+
+#~ msgid "Internal error adding a diversion"
+#~ msgstr "內部錯誤：在新增抽換資料時發生錯誤"
+
+#~ msgid "The pkg cache must be initialized first"
+#~ msgstr "套件快取必須先初始化"
+
+#~ msgid "Failed to find a Package: header, offset %lu"
+#~ msgstr "找不到套件：檔案標頭，位移 %lu"
+
+#~ msgid "Bad ConfFile section in the status file. Offset %lu"
+#~ msgstr "在 status 檔中的 ConfFile 區段損壞。位移 %lu"
+
+#~ msgid "Error parsing MD5. Offset %lu"
+#~ msgstr "在解析 MD5 時發生錯誤。位移 %lu"
+
+#~ msgid "Couldn't change to %s"
+#~ msgstr "無法切換至 %s"
+
+#~ msgid "Failed to locate a valid control file"
+#~ msgstr "找不到可用的 control 檔"
+
+#~ msgid "Couldn't open pipe for %s"
+#~ msgstr "無法開啟管線給 %s 使用"
+
+#~ msgid "Read error from %s process"
+#~ msgstr "由 %s 程序讀取錯誤"
+
+#~ msgid "Got a single header line over %u chars"
+#~ msgstr "取得一個單行超過 %u 字元的標頭"
+
+#~ msgid "Malformed override %s line %lu #1"
+#~ msgstr "重新定義檔 %s 第 %lu 行的格式錯誤 #1"
+
+#~ msgid "Malformed override %s line %lu #2"
+#~ msgstr "重新定義檔 %s 第 %lu 行的格式錯誤 #2"
+
+#~ msgid "Malformed override %s line %lu #3"
+#~ msgstr "重新定義檔 %s 第 %lu 行的格式錯誤 #3"
+
+#~ msgid "decompressor"
+#~ msgstr "解壓縮程式"
+
+#~ msgid "read, still have %lu to read but none left"
+#~ msgstr "讀取，仍有 %lu 未讀但已無空間"
+
+#~ msgid "write, still have %lu to write but couldn't"
+#~ msgstr "寫入，仍有 %lu 待寫入但已沒辨法"
+
+#~ msgid "Error occurred while processing %s (NewPackage)"
+#~ msgstr "在處理 %s 時發生錯誤 (NewPackage)"
+
+#~ msgid "Error occurred while processing %s (UsePackage1)"
+#~ msgstr "在處理 %s 時發生錯誤 (UsePackage1)"
+
+#~ msgid "Error occurred while processing %s (NewFileDesc1)"
+#~ msgstr "在處理 %s 時發生錯誤 (NewFileDesc1)"
+
+#~ msgid "Error occurred while processing %s (UsePackage2)"
+#~ msgstr "在處理 %s 時發生錯誤 (UsePackage2)"
+
+#~ msgid "Error occurred while processing %s (NewFileVer1)"
+#~ msgstr "在處理 %s 時發生錯誤 (NewFileVer1)"
+
+#, fuzzy
+#~ msgid "Error occurred while processing %s (NewVersion%d)"
+#~ msgstr "在處理 %s 時發生錯誤 (NewVersion1)"
+
+#~ msgid "Error occurred while processing %s (UsePackage3)"
+#~ msgstr "在處理 %s 時發生錯誤 (UsePackage3)"
+
+#~ msgid "Error occurred while processing %s (NewFileDesc2)"
+#~ msgstr "在處理 %s 時發生錯誤 (NewFileDesc2)"
+
+#~ msgid "Error occurred while processing %s (FindPkg)"
+#~ msgstr "在處理 %s 時發生錯誤 (FindPkg)"
+
+#~ msgid "Error occurred while processing %s (CollectFileProvides)"
+#~ msgstr "在處理 %s 時發生錯誤 (CollectFileProvides)"
+
+#~ msgid "Internal error, could not locate member"
+#~ msgstr "內部錯誤：無法找到成員"
+
+#, fuzzy
+#~ msgid "Release file expired, ignoring %s (invalid since %s)"
+#~ msgstr "Release 檔已過期，略過 %s（有效期限 %s）"
projects / apt.git / blobdiff