+#: apt-pkg/deb/dpkgpm.cc:1050
+msgid "Is /dev/pts mounted?"
+msgstr ""
+
+#: apt-pkg/deb/dpkgpm.cc:1071
+msgid "Is stdout a terminal?"
+msgstr ""
+
+#: apt-pkg/deb/dpkgpm.cc:1559
+msgid "Operation was interrupted before it could finish"
+msgstr ""
+
+#: apt-pkg/deb/dpkgpm.cc:1621
+msgid "No apport report written because MaxReports is reached already"
+msgstr ""
+
+#. check if its not a follow up error
+#: apt-pkg/deb/dpkgpm.cc:1626
+msgid "dependency problems - leaving unconfigured"
+msgstr ""
+
+#: apt-pkg/deb/dpkgpm.cc:1628
+msgid ""
+"No apport report written because the error message indicates its a followup "
+"error from a previous failure."
+msgstr ""
+
+#: apt-pkg/deb/dpkgpm.cc:1634
+msgid ""
+"No apport report written because the error message indicates a disk full "
+"error"
+msgstr ""
+
+#: apt-pkg/deb/dpkgpm.cc:1641
+msgid ""
+"No apport report written because the error message indicates a out of memory "
+"error"
+msgstr ""
+
+#: apt-pkg/deb/dpkgpm.cc:1648 apt-pkg/deb/dpkgpm.cc:1654
+msgid ""
+"No apport report written because the error message indicates an issue on the "
+"local system"
+msgstr ""
+
+#: apt-pkg/deb/dpkgpm.cc:1675
+msgid ""
+"No apport report written because the error message indicates a dpkg I/O error"
+msgstr ""
+
+#: apt-pkg/deb/debsystem.cc:84
+#, c-format
+msgid ""
+"Unable to lock the administration directory (%s), is another process using "
+"it?"
+msgstr ""
+
+#: apt-pkg/deb/debsystem.cc:87
+#, fuzzy, c-format
+msgid "Unable to lock the administration directory (%s), are you root?"
+msgstr "無法鎖定列表目錄"
+
+#. TRANSLATORS: the %s contains the recovery command, usually
+#. dpkg --configure -a
+#: apt-pkg/deb/debsystem.cc:103
+#, c-format
+msgid ""
+"dpkg was interrupted, you must manually run '%s' to correct the problem. "
+msgstr ""
+
+#: apt-pkg/deb/debsystem.cc:121
+msgid "Not locked"
+msgstr ""
+
+#, fuzzy
+#~ msgid "Note, selecting '%s' for task '%s'\n"
+#~ msgstr "注意，根據正規表示式 '%2$s' 而選擇了 %1$s\n"
+
+#, fuzzy
+#~ msgid "Note, selecting '%s' for regex '%s'\n"
+#~ msgstr "注意，根據正規表示式 '%2$s' 而選擇了 %1$s\n"
+
+#~ msgid "Package %s is a virtual package provided by:\n"
+#~ msgstr "套件 %s 是虛擬套件，提供者為：\n"
+
+#, fuzzy
+#~ msgid " [Not candidate version]"
+#~ msgstr "候選版本"
+
+#~ msgid "You should explicitly select one to install."
+#~ msgstr "請您明確地選擇一個來進行安裝。"
+
+#~ msgid ""
+#~ "Package %s is not available, but is referred to by another package.\n"
+#~ "This may mean that the package is missing, has been obsoleted, or\n"
+#~ "is only available from another source\n"
+#~ msgstr ""
+#~ "無法取得套件 %s，但它卻被其它的套件引用了。\n"
+#~ "這意味著這個套件可能已經消失了、被廢棄了，或是只能由其他的來源取得\n"
+
+#~ msgid "However the following packages replace it:"
+#~ msgstr "然而，下列的套件取代了它："
+
+#, fuzzy
+#~ msgid "Package '%s' has no installation candidate"
+#~ msgstr "套件 %s 沒有可安裝的候選版本"
+
+#, fuzzy
+#~ msgid "Package '%s' is not installed, so not removed. Did you mean '%s'?\n"
+#~ msgstr "套件 %s 並沒有被安裝，所以也不會被移除\n"
+
+#, fuzzy
+#~ msgid "Package '%s' is not installed, so not removed\n"
+#~ msgstr "套件 %s 並沒有被安裝，所以也不會被移除\n"
+
+#, fuzzy
+#~ msgid "Note, selecting '%s' instead of '%s'\n"
+#~ msgstr "注意，選擇了以 %s 替代 %s\n"
+
+#~ msgid "Skipping %s, it is already installed and upgrade is not set.\n"
+#~ msgstr "忽略 %s，它已被安裝且沒有計劃要進行升級。\n"
+
+#, fuzzy
+#~ msgid "Skipping %s, it is not installed and only upgrades are requested.\n"
+#~ msgstr "忽略 %s，它已被安裝且沒有計劃要進行升級。\n"
+
+#~ msgid "Reinstallation of %s is not possible, it cannot be downloaded.\n"
+#~ msgstr "無法重新安裝 %s，因為它無法下載。\n"
+
+#~ msgid "%s is already the newest version.\n"
+#~ msgstr "%s 已經是最新版本了。\n"
+
+#, fuzzy
+#~ msgid "Selected version '%s' (%s) for '%s'\n"
+#~ msgstr "選定的版本為 %3$s 的 %1$s (%2$s)\n"
+
+#, fuzzy
+#~ msgid "Selected version '%s' (%s) for '%s' because of '%s'\n"
+#~ msgstr "選定的版本為 %3$s 的 %1$s (%2$s)\n"
+
+#~ msgid "This is not a valid DEB archive, it has no '%s', '%s' or '%s' member"
+#~ msgstr "這是個不正確的 DEB 套件檔，沒有 '%s', '%s' 或 '%s' 成員"
+
+#~ msgid "MD5Sum mismatch"
+#~ msgstr "MD5Sum 不符"
+
+#~ msgid ""
+#~ "I wasn't able to locate a file for the %s package. This might mean you "
+#~ "need to manually fix this package."
+#~ msgstr "找不到 %s 套件的某個檔案。這意味著您可能要手動修復這個套件。"
+
+#~ msgid "Can not write log, openpty() failed (/dev/pts not mounted?)\n"
+#~ msgstr "無法寫入記錄檔，openpty() 失敗（/dev/pts 未掛載？）\n"
+
+#, fuzzy
+#~ msgid "Skipping nonexistent file %s"
+#~ msgstr "開啟設定檔 %s"
+
+#~ msgid "Failed to remove %s"
+#~ msgstr "無法移除 %s"
+
+#~ msgid "Unable to create %s"
+#~ msgstr "無法建立 %s"
+
+#~ msgid "Failed to stat %sinfo"
+#~ msgstr "無法取得 %sinfo 的狀態"
+
+#~ msgid "The info and temp directories need to be on the same filesystem"
+#~ msgstr "資料目錄與暫存目錄需位於同一檔案系統中"
+
+#~ msgid "Failed to change to the admin dir %sinfo"
+#~ msgstr "無法切換至管理者目錄 %sinfo"
+
+#~ msgid "Internal error getting a package name"
+#~ msgstr "內部錯誤，無法取得套件名稱"
+
+#~ msgid "Reading file listing"
+#~ msgstr "正在讀取檔案清單"
projects / apt.git / blobdiff