BITCOUNT: fix segmentation fault.

[redis.git] / sentinel.conf

diff --git a/sentinel.conf b/sentinel.conf
index 45c34401de386ad9631a1d23dc0a70ca67e196fe..34d185c4b79e3513a057c416251b2f88babfda38 100644 (file)
--- a/sentinel.conf
+++ b/sentinel.conf
@@ -52,6 +52,27 @@ sentinel parallel-syncs mymaster 1
 # Default is 15 minutes.
 sentinel failover-timeout mymaster 900000
 
+# SCRIPTS EXECTION
+#
+# sentinel notification-script and sentinel reconfig-script are used in order
+# to configure scripts that are called to notify the system administrator
+# or to reconfigure clients after a failover. The scripts are executed
+# with the following rules for error handling:
+#
+# If script exists with "1" the execution is retried later (up to a maximum
+# number of times currently set to 10).
+#
+# If script exists with "2" (or an higher value) the script execution is
+# not retried.
+#
+# If script terminates because it receives a signal the behavior is the same
+# as exit code 1.
+#
+# A script has a maximum running time of 60 seconds. After this limit is
+# reached the script is terminated with a SIGKILL and the execution retried.
+
+# NOTIFICATION SCRIPT
+#
 # sentinel notification-script <master-name> <script-path>
 # 
 # Call the specified notification script for any sentienl event that is
@@ -70,4 +91,41 @@ sentinel failover-timeout mymaster 900000
 #
 # sentinel notification-script mymaster /var/redis/notify.sh
 
+# CLIENTS RECONFIGURATION SCRIPT
+#
+# sentinel client-reconfig-script <master-name> <script-path>
+#
+# When the failover starts, ends, or is aborted, a script can be called in
+# order to perform application-specific tasks to notify the clients that the
+# configuration has changed and the master is at a different address.
+# 
+# The script is called in the following cases:
+#
+# Failover started (a slave is already promoted)
+# Failover finished (all the additional slaves already reconfigured)
+# Failover aborted (in that case the script was previously called when the
+#                   failover started, and now gets called again with swapped
+#                   addresses).
+#
+# The following arguments are passed to the script:
+#
+# <master-name> <role> <state> <from-ip> <from-port> <to-ip> <to-port>
+#
+# <state> is "start", "end" or "abort"
+# <role> is either "leader" or "observer"
+# 
+# The arguments from-ip, from-port, to-ip, to-port are used to communicate
+# the old address of the master and the new address of the elected slave
+# (now a master) in the case state is "start" or "end".
+#
+# For abort instead the "from" is the address of the promoted slave and
+# "to" is the address of the original master address, since the failover
+# was aborted.
+#
+# This script should be resistant to multiple invocations.
+#
+# Example:
+#
+# sentinel client-reconfig-script mymaster /var/redis/reconfig.sh
+