X-Git-Url: https://git.saurik.com/redis.git/blobdiff_plain/7c9bfe10367a50c44aec53a59da14f2540f82aa4..a2b3fff23535d41b7bce6e4fac1bb5b6f4f15355:/sentinel.conf

diff --git a/sentinel.conf b/sentinel.conf
index 367b3de4..94169ee8 100644
--- a/sentinel.conf
+++ b/sentinel.conf
@@ -13,6 +13,25 @@ port 26379
 # The valid charset is A-z 0-9 and the three characters ".-_".
 sentinel monitor mymaster 127.0.0.1 6379 2
 
+# sentinel auth-pass <master-name> <password>
+#
+# Set the password to use to authenticate with the master and slaves.
+# Useful if there is a password set in the Redis instances to monitor.
+#
+# Note that the master password is also used for slaves, so it is not
+# possible to set a different password in masters and slaves instances
+# if you want to be able to monitor these instances with Sentinel.
+#
+# However you can have Redis instances without the authentication enabled
+# mixed with Redis instances requiring the authentication (as long as the
+# password set is the same for all the instances requiring the password) as
+# the AUTH command will have no effect in Redis instances with authentication
+# switched off.
+#
+# Example:
+#
+# sentinel auth-pass mymaster MySUPER--secret-0123passw0rd
+
 # sentinel down-after-milliseconds <master-name> <milliseconds>
 #
 # Number of milliseconds the master (or any attached slave or sentinel) should
@@ -91,4 +110,41 @@ sentinel failover-timeout mymaster 900000
 #
 # sentinel notification-script mymaster /var/redis/notify.sh
 
+# CLIENTS RECONFIGURATION SCRIPT
+#
+# sentinel client-reconfig-script <master-name> <script-path>
+#
+# When the failover starts, ends, or is aborted, a script can be called in
+# order to perform application-specific tasks to notify the clients that the
+# configuration has changed and the master is at a different address.
+# 
+# The script is called in the following cases:
+#
+# Failover started (a slave is already promoted)
+# Failover finished (all the additional slaves already reconfigured)
+# Failover aborted (in that case the script was previously called when the
+#                   failover started, and now gets called again with swapped
+#                   addresses).
+#
+# The following arguments are passed to the script:
+#
+# <master-name> <role> <state> <from-ip> <from-port> <to-ip> <to-port>
+#
+# <state> is "start", "end" or "abort"
+# <role> is either "leader" or "observer"
+# 
+# The arguments from-ip, from-port, to-ip, to-port are used to communicate
+# the old address of the master and the new address of the elected slave
+# (now a master) in the case state is "start" or "end".
+#
+# For abort instead the "from" is the address of the promoted slave and
+# "to" is the address of the original master address, since the failover
+# was aborted.
+#
+# This script should be resistant to multiple invocations.
+#
+# Example:
+#
+# sentinel client-reconfig-script mymaster /var/redis/reconfig.sh
+